HUB-TC
Control board
It manages up to 4 zones (4 couples – 8 columns) 4 alarm NC outputs on single zones.
1 tamper NC output.
Open collector disqualification and failure outputs.
4 stand-by independent inputs for single zones. RS232 port to connect PC softwares. Power supply 12Vdc – Current max. 100mA + 200mA for
each barrier.
Available on request the special version HUB-RTC dedicated for
the integration in complex systems on bus RS485 (max. 16 devices). It
requires software developed by a system integrator with integration of the proprietary protocol (after signing a Privacy agreement).
TBS
Test meter
Field tester for alignment and control of each single ray. Led indication. Simulation trimmer of attenuation for low visibility.
SYNC
Synchronizer
It allows to synchronize amongs them up to 8 HUB-TC to cohexist in the same area up to 32 barriers, total 256 beams/1024 rays (protection up to a 2,56 linear Km x 2 meters heigh). Power supply 12Vdc.
TRAC
Transformers
Transformers for thermostat heating of Photon barriers. Outdoor case IP68 (immersion protection) with derivations protected by 4 cable-glands PG. Power supply 230Vac
TRAC1824
Transformer for: 1 pair of 2m or 1,5m barriers
TRAC612
Transformer for: 2 pairs of 1m or 0,5m barriers
GIUNTO 68
Junction box
For segment extension. Outdoor case IP68 with 2 PG cable glands. 5 poles terminal block.
LE
Line extender
It divides electrically 4 segments connected to HUB maintening functioning in case of out of order in a zone. It allows also to double the maximum distance of connection between HUB and barriers, saving on cables (maximum distance between HUB and LE 1Km). Power supply 12Vdc.
CAVO-HUB
Bus cable
Cable alarm type 4 conductors shielded low capacity (GRADE 4), blue sheath, 2×0,75+2×0,35 (twisted)+shield
ALBA-M
Power supply
Power supply 230Vac/12Vdc 3,6A in metallic case with space for backup lead battery 12V 17Ah MAX (not included). One power supply is sufficient for 3 HUB with related 12 barriers.
BA
Pole base
Fixing base for pole to be drowned in the concrete of a well – Ø 30cm – compatible with mod. PA
PA
Support pole
Metallic pole 40x40mm pre-drilled for the mounting of Photon barriers, round base Ø 30cm for floor mounting. Varnished with black powder.
PA200
Pole h.220cm for 2m barriers
PA150
Pole h.170cm for 1,5m barriers
SCAP 68
Junction box
IP68 box with derivations protected by 4 cables. 5 poles terminal block.
